Hydraulic Equipment & Tools Ultra-high Pressure ~ 700 ~ 2000bar


HYDRAULIC TOOLS before home next print
 
  Oil-L-Jacks   Hyd Puller   Knockout Punch   Terminal, Pipe Crimping Press           Pipe Benders   Cable Cutter   Shop Press   Angle Cutter   Hyd Wrench         Bolt Tensioners   Al-Pulling Jacks   Hyd Jacks   Steel bar Cutter   Hyd Punch     Major Products

   HYDRAULIC KNOCKOUT PUNCH          1/2" ~ 4"


  • Punching Capacity : 1/2" ~ 4"

  • Cylinder Capacity : 10 ~ 15tons

  • Maximum Pressure:700bar

  • Easy hole punching on steel sheets and

    plates at control panels.

    • Specfication

    Model Capacity
    (tons)    		 Punching
    Thickness
    (mm)    		 Max.
    Punching
    Dia.    		 Operation
    Method     		Weight
    (kgs)
    SDKP-2 10 2.8 1/2"~2" Hand & Moter Pump 6
    SDKP-4 10 3.2 1/2"~4" 8

    Specfication

    Model SDKP-2 SDKP-4 Set Screw Rod Dia.
    B16(1/2") 21.9 21.9 3/8" 11(mm)
    B22(3/4") 27.5 27.5 3/4" Operation Method :

    After make a hole with drill,
    punch is used enlarge a
    drill hole.

    B28(1") 34.2 34.2
    B36(1 1/4") 42.7 42.7
    B42(1 1/2") 48.3 48.3
    B54(2") 60.7 60.7
    B70(2 1/2") - 76.5
    B82(3") - 89.3
    B92(3 1/2") - 101.9
    B104(4") - 114.7

    Custom made for special requirements

    Tel : 82-32-670-8635 ~ 9   Fax : 82-505-813-0415
    http://www.hydtools.com                    
    Copyright(c)1998 by Sonar Solomon Corporation All Rights Reserved.